Det här arbetet har gått ut på att jämföra två algoritmer för bildbaserad rendering. Båda algoritmerna använder två bilder som spelats in med formatet MultiView plus Depth för att rendera nya mellanliggande vyer av en tredimensionell scen. De tvådimensionella bilderna är kompletterade med djupvärden för varje bildpunkt. Renderingen kan då utföras genom perspektivriktiga transformationer där alla bildpunkters nya positioner projiceras individuellt. I samband med renderingen behöver bland annat mätfel i de ursprungliga bilderna samt skymda partier hanteras.

Digital depth-to-water maps can be produced from a digital elevation model (DEM). Then GIS- based algorithms are used to calculate water flows and the depth-to-water index classes dry, fresh, moist and wet. The purpose of this study was to investigate the possibility to use depth- to-water maps for site adapted planting.The results showed that use of depth-to-water maps for site adapted planting, roughly halved the proportion of improperly planted surfaces from an average of 9 % to 4 %. The variation in the values of proper surface decreased and the result became more even.. In addition, more pine than spruce was incorrectly planted.

The thick-shelled river mussel (Unio crassus) is a red listed species classified as Endangered (EN) and is also considered within the Habitats Directive. The distribution in Sweden is fragmented and it is mostly occurring in the south eastern parts. We investigated the presence of Unio crassus in a section of the stream Storån, Östergötland County, from Falerum to the inflow into Lake Åkervristen. The environmental parameters investigated were water depth, bottom substrate, shading, water velocity and the slope over the water surface. In this thesis I have focused mainly on water depth and shading, comparing sites with and without mussels.

This literature study concerned the use and function of the radioactive isotope carbon-14, as a dating method of organic material, within the scientific field of physical geography. In this report it is presented the need of atmospheric calibration curves and the development of these as a necessity to translate carbon-14 years to calibrated calendar years. A number of common age-depth models that is used to give an approximation of an accumulation sequence and its related dates over the actual time period in different natural archives is presented and discussed. Different problems that commonly occur when age-depth models are utilized as for instance reservoir effects, contaminations or other age deviations are addressed and analyzed. The software CLAM in presented and discussed and was also used to produce age-depth models.

Tussilago farfara, coltsfoot, is a troublesome perennial weed with deep lying rhizome, which can vegetatively generate new plants. The mechanical control of coltsfoot that is used today, "starvation", which consists of several cultivations of the soil, which fragmentises the rhizome. This results in production of new shoots, which leads to depletion of nutrient resources; as long the new plant is not allowed to establish. However, very little research has been done to investigate how the starving technique affects the regenerative ability of coltsfoot. The purpose of this experiment with coltsfoot was to investigate how fragmentation and burial depths affect the time of emergence, number of emerged shoots per rhizome fragment, number of shoots per node, and if the germination ability within nodes changes during the experiment.

The global climate-change means increasing mean-temperature and higher precipitation in Sweden, which leads to shorter periods of frozen ground in the forest. At the same time the harvesting machines are getting bigger and more powerful. The forest industry aim at an even wood flow, and the ground damage has to be as low as possible. The two biggest causes for ground-damage is the bearing capacity of the forest ground and the ground-pressure of the harvesting machines. The aim of this study was to find out some rules for the machine choice considering ground pressure, when harvesting on ground with low bearing capacity.A field study, using a Valmet 890.3 forwarder, was carried out where different ground pressures and their effect on the ground were tested on two different types of ground.Additionally, an inventory of damaged harvesting grounds was made.

During cold winter days it is likely that people in buildings with older windows or high glass facades experience thermal discomfort due to cold air down draughts. Earlier work has been aimed at finding analytical methods to predict the speed of the airflow in a room and in practice heating appliances are often placed beneath the windows to reduce the draught along the floor. In a study from 2012 Mohammad Parchami developed a method for estimating the required heating power to counteract the downdraught with such heating appliances. In this study, Computational Fluid Dynamics (CFD) was used to evaluate the usefulness of Parchami?s method and also to examine the potential of adapting the depth of the inward window sill as a means of decreasing the down draught.

The purpose of this work is to examine how ecotourism exists in Sweden. In order to answer this, the essay has been based on a qualitative method, which means that the authors have mainly used depth interviews for information gathering. Some of the empirical work is also done using the qualitative method, by gathering statistics, figures and scientific articles. The essay is divided into various chapters to give the essay a clear structure and for the convenience of the reader. The part that have been of most use and support for authors is the depth interviews with the interviewees.

Studies have shown that air pollution, as well as bark fissure depth and sun exposure of a tree can have an effect on lichen growth as well as abundance of lichen species. The aim of this study was to find out the relative importance of these factors. 211 oaks in south eastern Sweden were surveyed for presence of 17 lichen species, as well as the total number of lichen species. Half of the trees were situated in urban areas and half in the countryside. For each tree the bark fissure depth was measured and the sun exposure of the trunk was estimated.

The plants in the genus Elatine are characteristic for oligo and mesotrophic lakes. This study focuses on Elatine hexandra one of the four species in Sweden. It is stated as vulnerable by the National Environment Agency and a conservation plan with guidelines to preserve the plant in Sweden is under preparation. There have been a few previous studies investigating this plant in other countries but this is the first one for Sweden. The aim of this study was to investigate the distribution, growth and reproduction of E.

The Kverneland Ecomat and The Ecomat Seeder has been tested in three different field studies. All the studies were conducted on soils with different clay content during 2005 in Säby outside Uppsala. In one of the trial spring ploughing with the Ecomat and spring ploughing and seeding with Ecomat Seeder were compared with conventional autumn mouldboard ploughing and spring mouldboard ploughing to conventional depth (22-23 cm). In this study the quality of the seedbed, the number of emerged plants and weeds, the pentration resistance and the yield were examined. Shallow spring ploughing (10 cm) with the Kverneland Ecomat has shown to be a good alternative to conventional autumn ploughing when growing spring crops. During the season 2005 tilling with the Ecomat resulted in a higher yield than conventional ploughing. In 2002-2005 the average yield for shallow spring ploughing was 4 percent higher than after conventional autumn mouldboard ploughing and 10 percent higher than after spring mouldboard ploughing to conventional depth (22-23 cm). In the other two studies, ploughing to different depth in the autumn with the Ecomat was compared with conventional mouldboard ploughing and stubble discing.

After parturition the energy demand for milk production is greater then the energy provided from the diet. The cow mobilises therefore body tissues to compensate for the energy loss. Live weight and body condition scores decreases as a consequence of the mobilisation. The aim of this study was to analyse the relationship between body condition score, live weight and subcutaneous fat depth measured by ultrasound and the changes during the lactation. Possible differences between Swedish Holstein (SLB) and Swedish Red and White Cattle (SRB) were also investigated.

Fuel wood is currently the third largest assortment from the forest in Sweden after pulpwood and lumber. Branches and tops i.e. logging residues are one of the assortments of fuel wood which is a common by-product after harvesting nowadays. The way to utilize, disintegrate and transport the logging residues varies between northern and southern Sweden. Branches and tops are collected throughout the year at appropriate stands, but are consumed mainly wintertime.

Habitat selection of migratory brown trout at the upper reaches of River Vindelälven, wasstudied in September during the pre-spawning period. The fish migrate from down- orupriver lakes for spawning in the river and data was collected by habitat mapping andradio-telemetry. Habitat selection of fish was analysed with preference curves andstatistical modelling, using the physical variables; depth, stream velocity and streambedsubstrate. Preference curves were derived by comparing fish habitat use with their nearbyavailable environment while the statistical modelling aimed to answer three main questions.1) Do the trout have a specific preference of depth, water velocity and streambed substrate?2) Is there any difference in habitat selection between sexes? 3) Is there a shift in habitatselection over time? The preference curves indicated that trout favored water depths of 1-2m, velocity compositions characterized as glides (c.

The Swedish Transport Administration has, and manages, a database containing information of the status of road condition on all paved and governmental operated Swedish roads. The purpose of the database is to support the Pavement Management System (PMS). The PMS is used to identify sections of roads where there is a need for treatment, how to allocate resources and to get a general picture of the state of the road network condition. All major treatments should be reported which has not always been done.The road condition is measured using a number of indicators on e.g. the roads unevenness.